Simmons SD300KIT Owner's Manual page 6

SD KIT
OWNER'S MANUAL
Assembling your kit
Step 1 - Drum Rack
The Drum rack will be fully assembled in the box.
Remove the drum rack from the box and tighten the connecting
clamps until the kit is stable.
Step 3 - Attach Cymbal Pads
Remove wing nuts from cymbal tilters. Place cymbal pads on tilter
assembly. Re-attach and tighten wing nuts.
Step 5 - Position Pedals & Attach Drum Pads
Place the hi-hat pedal on the floor and to the left, as illustrated
below. Place the bass pedal on the floor in the center of the rack
as illustrated.
Loosen the wing screws on the drum mount clamps on the center
crossbar and the right side rack arm. Place the tom pads into the
mounts and tighten the wing screws.
Place the L arm into the drum mount clamp on the left side rack arm
(next to the Hi Hat). Slide the snare pad onto the L arm and tighten
the wing screw.
Step 6 - Connect Module to the Pads
Using the provided cables, connect the ¼" jacks to the corresponding
drum pads, cymbal pads and kick pad. (Cables are marked
accordingly). The pin connection will attach to the serial port of the
sound module. Assembly complete.
NOTE: The voice of the hi-hat pad is controlled by the hi-hat pedal. Similar to
a real drum kit, the hi-hat pad functions as an 'open hi-hat' when the pedal
is released. When the pedal is pressed down, it functions as a 'closed hi-hat'.
Use cable strips to retain cable to rack.
6
C
Step 2 - Attach Cymbal Arms
Insert each cymbal arm into the rack clamp. Insert (Long) hi-hat arm
on the left-side rack arm's cymbal clamp.
Step 4 - Attach Drum Module
Loosen wing screw on the module mount located on the crossbar. Place
drum module into drum clamp. Tighten wing screw to secure module.