Getting Started; Switching The Power On; Basic Operation And Navigation; Listening To The Demo Song - Simmons SD300KIT Owner's Manual

getting started

Switching the Power On

1. Connect the AC Adapter to the drum module.
2. Press the power switch on the front panel to turn on the module.
Note: There is an automatic power off function that turns off the
module when the kit is not being used for a certain period of time.
The default setting is Always ON. You can change this setting by
holding down the [KIT] button for two seconds. This will disable the
auto power off function. Press and hold the [KIT] button again to
switch it back on.

Basic Operation and Navigation

Selecting Modes
There are 3 main modes for the module KIT, SONG and UTILTY.
To enter these modes press the corresponding buttons on the top
panel of the module.
Adjusting Values
1. Select the parameter to be adjusted.
2. Adjust the value using [ - ] / [+] buttons.

Listening to the Demo Song

The demo song helps to show you the capabilities and sounds of
the SD300KIT module. There is one demo in the module. The demo
song is a medley that has several patterns combined to show the
different genres of music that the module can play.
1. Press the [SONG] button to enter Song Mode. Use the
[ - ] / [ + ] buttons to select song d-1.
2. Press the [START] button to start or stop the demo.
3. After stopping the demo, press any of the Mode buttons
(KIT, SONG or UTILITY) to exit the Demo Mode.
www.simmonsdrums.net
11