Wall Mounting - Dimplex QRAD050 Operating Instructions Manual

General
The heater is designed for wall mounting using the wall bracket supplied. It should
only be operated when in the upright position as shown - see Fig. 1 and Fig. 2. All
models are splash proof to IP24 standard and may be used in bathrooms, however
not in the immediate vicinity of baths, showers, water connections, wash basins or
swimming pools. Before connecting the heater check that the supply voltage is the
same as that stated on the heater.

Wall Mounting

IMPORTANT – The wall bracket supplied with the appliance
must be used. The heater should be positioned observing the
minimum clearances stated around the heater - see Fig. 1 and
Fig. 2.
DO NOT locate the heater immediately below a fixed socket
outlet or connection box.
1. Remove wall mounting bracket from the back of the heater
by depressing the spring latch at the top of each bracket -
see Fig. 3.
2. Fix the wall bracket securely to the wall through the four
screw holes provided.
3. Present the heater to the wall bracket, and engage lower
slots in the back with bracket.
4. Raise the heater to upright position and push the heater
onto bracket to engage top latches.
Dimensions
Model(s)
QRAD050
QRAD075
QRAD100
QRAD150
QRAD200
4
Watt (kW) A (mm)
0.50 kW 513
0.75 kW 513
1.0 kW 675
1.5 kW 756
2.0 kW 918