Hotpoint RJ734GP Use And Care Manual page 22

". ~--,: Use This Problem Solver
PROBLEM
OVEN WILL
NOT OPERATE
OVEN DOES NOT
COOK PROPERLY
CLOCK AND
MINUTE/SECOND
TIMER DO NOT WORK
OVEN LIGHT DOES
NOT COME ON
SELF-CLEANING
OVEN WILL NOT
SELF-CLEAN PROPERLT
DELAY SELF-CLEAN
CYCLE WILL NOT
START
SELF-CLEANING
OVEN DOOR WILL
NOT UNLOCK
CONTROL BEEPS
AFTER ENTERING
OVEN TIME OR
STOP TIME
"F-" AND A NUMBER
FLASH ON DISPLAY
more help...call, toll free:
need
800.626.2000
consumer information service
22
POSSIBLE CAUSE AND REMEDY
Difficulty may be in the main distribution panel of your house by a blown oven
circuit fuse, a tripped oven circuit breaker, the main fuse or the main circuit breaker,
depending on nature of the power supply. [f a circuit breaker is involved, reset it. If the
control box uses fuses, the oven fuse (a cartridge-type) should be changed BUT
ONLY BY SOMEONE FAMILIAR WITH ELECTRICAL CIRCUITS. If after doing
one of these procedures, the fuse blows or circuit breaker trips again, call for service.
NOTE: Apartment tenants or condominium owners should request their building
management to perform this check before calling for service.
Oven controls not properly set.
Aluminum foil being used improperly in oven.
Incorrect cookware being used. Check each cooking section for cookware tips.
Electronic Controls or Lower Oven Control set incorrectly, Review sections on
Electronic Oven Control.
Check common baking, roasting and broiling problems on appropriate pages.
Check circuit breaker or fuse.
Check for power outage.
Bulb may be loose or burned out.
Electrical plug must be plugged into a live power outlet.
Switch operating oven light is broken. Call for service.
Fan not operating.
Oven temperature is too high to set self-clean operation. Allow the oven to cool to
room temperature and reset the controls.
Door not closed securely.
STOP TIME must be between 2 to 4 hours later than START TIME.
Oven hasn't cooled to a safe temperature.
This is reminding you to enter a bake temperature (see Baking section of this book).
CLEAR/OFF. If the failure code repeats, disconnect all power to the range. Call for service.