Hotpoint RJ734GP Use And Care Manual page 19

Clean Time is normally 3 hours.
You can change the Clean Time to
anywhere between 2 and 4 hours,
depending on how dirty the oven is.
The self-clean cycle will
automatically begin after "LOCK"
is displayed and the word "ON"
will appear on the display. When
the word "LOCK" is displayed, it
will not be possible to open the
oven door until the temperature
drops below the lock temperature.
When the clean cycle is finished,
the word "CLEAN" will go out in
the display and the oven will begin
to cool. When the oven
temperature has fallen below the
locking temperature (about 20-30
minutes after the word "CLEAN"
goes out at the end of the clean
cycle), the word "LOCK" goes
out and the door can be opened.
the word
Step 6: Wait until
before opening the oven door.
How to Delay Start
of Cleaning
Delay Start is setting the oven
timer to start the clean cycle
automatically at a later time than
the present time of day. NOTE:
Before beginning make sure the
oven clock shows the correct time
of day.
Quick Reminder—
Delay Start for Self-Clean:
1.) Prepare oven for cleaning.
2.) Touch CLEAN pad.
3.) Touch INCREASE pad.
4.) Touch STOP TIME pad.
Time that appears is 3 hours
INCREASE pad until the Stop
Time you desire appears in the
display. The self-clean cycle
will automatically begin 3 hours
before the stop time you select.
For example: Let's say it's 7:00
and you want the oven to begin
self-cleaning at 9:00 after you're
finished in the kitchen. The oven
is just soiled a normal amount so
the normal Clean Time of 3 hours
is preferred.
Step 1: Prepare the oven for cleaning.
Step 2: Close the oven door and
make sure the oven light is off.
Oven door will lock automatically.
Step 3: Touch CLEAN pad.
Step 4: Touch INCREASE pad.
Step 5: Clean Time for heavy soil
can be set for 4 hours. If longer or
shorter Clean Time is desired,
press lNCREASE/DECREASE
pad until desired Clean Time is
displayed.
Step
6: Touch STOP TIME pad.
Earliest possible stop time appears
on display and "STOP TIME"
flashes. The control automatically
sets Stop Time by adding the
Clean Time to the time of day. In
this example, the time of day is
hours. Adding 3 hours to the time
of day equals 10:00.
Step 7: Change Stop Time from
INCREASE pad until " 12:00"
appears in the display.
The words "DELAY CLEAN"
will also appear in the display.
The self-clean cycle will
automatically begin at 9:00 and
finish at 12:00. The word "ON"
The word "LOCK" will be
displayed a few seconds after
entering clean time. If "DOOR" is
displayed, close the door. It will
not be possible to open the oven
door until the temperature drops
below the lock temperature.
When the clean cycle is finished,
the word "CLEAN" will go out
in the display and the oven will
begin to cool. When the oven
temperature has fallen below the
locking temperature (about 20-30
minutes after the word "CLEAN"
goes out at the end of the clean
cycle), the word "LOCK" goes
out and the door can be opened.
Step
8: Wait until the word
"LOCK" goes out in the display
before opening the door.
19