Table of Contents
Advertisement
EDL MODEL 6115, 6116, 6119 & 6120
MASTERSYNC MONITOR SPECIFICATIONS
DEFLECTION
SCAN RATE RANGES:
interlaced and 20-60 Hz interlaced vertical. Automatic selection to match input video
format.
RETRACE TIME:
vertical.
HORIZONTAL AND VERTICAL SYNC:
composite (3 wire), separate video and mixed sync (4 wire), and separate video, vertical
and horizontal sync (5 wire). Polarity: Negative only for three wire operation. Positive or
negative for four and five wire operation. Separate sync inputs are ECL and TTL
compatible 1.0 to 4.0 volts peak to peak.
LINEARITY:
Horizontal and vertical nonlinearity (when measured using the EIA Standard
Ball Chart Method or equivalent) is better than +1% raster height.
RASTER SIZE REGULATION:
current from 0-100% APL (approximately 0 to 200 Microamps) will be less than 0.5%.
GEOMETRIC DISTORTION:
proper position by more than 1% of raster height within a 9 inch circle (Model 6115 &
6116) and within an 11 inch circle (Model 6119 & 6120) and no more than 1.5%
elsewhere.
MISCONVERGENCE:
misconvergence will be less than 0.2mm and elsewhere will be less than 0.4mm when
measured as the worse case between any two colors.
POWER REQUIREMENT
A.C. POWER:
Input voltage 90-132 v.a.c. or 180-264 v.a.c. switch selectable inside the
monitor, 47 to 63 Hz. Power Consumption 150 Watts maximum.
6115 - 6120 Operation and Maintenance Manual
SPECIFICATIONS
Horizontal scan rates from 15 to 90 kHz, 40 to 120 Hz non-
Maximum of 3.0 microseconds horizontal and 400 microseconds
Raster size change caused by changes in CRT beam
No point on the raster (i.e., pixel) is displaced from its
Within a centrally located circle of six inch diameter
4
Automatic detection and selection of
©EDL Displays, Inc. January 1997
Advertisement
Table of Contents
Troubleshooting
