Table of Contents
Advertisement
GENERAL
This section describes the installation of the monitor. The monitor is pre-aligned at the
factory to user input requirements. However, there may still be the need for some minor
adjustments to be made. Those procedures will be provided later in the Calibration
Procedures section.
UNPACKING
Before unpacking, the carton should be inspected for shipping damage. The carton
should be carefully opened and the monitor removed.
carefully inspected for shipping damage. If damage has occurred, the shipping carton
and all packing materials should be saved for possible inspection by the shipping
company. The shipping company and EDL Displays should be notified at this time.
AC POWER CONNECTION
Before connecting the monitor, determine what a.c. power is to be used and make sure
that the monitor is configured properly for that voltage. NOTE: The power setting upon
shipment is 110 volts unless otherwise requested by the customer. The voltage of the
monitor may be changed at the power supply module accessible from the rear of the unit.
The power supply must be removed for access to the voltage select switch (see figure
4).
MECHANICAL INSTALLATION
The 6119 monitor is designed to be mounted and secured in place on any flat surface by
four 10-32 X 1/2 inch screws into the bottom panel. See figure 3 for the hole pattern
required. (Model 6119 only)
OPTIONAL RACK MOUNT
As an option, the Model 6119-8 is provided with an all steel chassis and bezel assembly.
This option includes heavy duty slides and requires only 15.75 inches of panel space.
6115 - 6120 Operation and Maintenance Manual
INSTALLATION
9
The monitor should then be
©EDL Displays, Inc. January 1997
Advertisement
Table of Contents
Troubleshooting
