Hanging The Fan - Home Decorators MERWRY Use And Care Manual

Assembly — Hanging the Fan (continued)
5
Hanging the fan motor assembly
from the mounting bracket
□
Lift the fan motor assembly (H) into position, and place the
hanger ball (E) into the mounting bracket (B). Rotate the
fan motor assembly (H) until the check groove drops into
the registration slot (NN) and seats rmly. The downrod (F)
should not rotate if this is done correctly.
6
Preparing the receiver and remote
control
WARNING: To avoid possible electrical shock, ensure the
electricity is turned off at the main fuse box before wiring.
CAUTION: Do not use with a wall light dimmer switch.
If you feel you do not have enough electrical
NOTE:
wiring knowledge or experience, have your fan installed
by a licensed electrician.
This remote control unit is equipped with 16 code
combinations to prevent possible interference from or to
other remote units. The frequency switches on your
receiver (L) and remote control (M) have been preset at
the factory. Please recheck to make sure the switches on
the remote control (M) and the receiver (L) are set to the
same position. Any combination of settings will operate
the fan as long as the remote control (M) and receiver
(L) are set to the same position.
□
Insert the receiver (L) into the mounting bracket (B)
with the flat side of the receiver (L) facing the
ceiling.
B
NN
10
F
L
M
L
B
E