Table of Contents
Advertisement
Folding the wheelchair
-
Fold away the foot plates and remove the foot or leg rest, see chapter 5.3;
-
Make sure you are next to the wheelchair;
-
Get a hold of the seat material at the front and rear in the middle and pull it straight up, see figure 2;
-
Tilt the wheelchair slightly and then push the sides toward each other to completely fold the wheelchair.
5.3 Use of the footplate and footrest
Folding the footplate away
-
Go to the front of the wheelchair and get a hold of the front of the foot plate;
-
Fold the footplate in the direction of the footrest.
Removing the footrests from the wheelchair
-
Go to the front of the wheelchair;
-
Push the black control lever away from you. You can now swing the footrest inwards and outwards;
-
Swing the footrests 90˚ to the outside of your wheelchair and pull the complete footrest straight up from the
tube.
Placing the footrest back on your wheelchair
-
Go to the front of the wheelchair;
-
Place the footrest with an angle of 90°back on the tube;
-
Swing the footrest to the front until you hear a click. This click confirmed that the foot is in position.
Setting height of the footplate
To adjust the height of the footplate you need to use Allen Key number 5.
-
Go to the side of the wheelchair, you will notice a black cube;
-
Loosen with Allen Key number 5 the bolt in the black cube until you can move the footrest up and down;
-
Select the desired height and tighten the bolt down;
-
Make sure the footplate is in place and that the length is equal on both sides.
Figure 1
Figure 3
~ 13 ~
Overall user manual
Figure 2
Figure 4
Advertisement
Table of Contents
