Using The Wheelchair Brake; Using The Armrest - 2GOability Infineon XS5000 User Manual

Setting the height of the calf plate
- Turn the calf plate loose, using the Allen Key number 5.
- Remoeve the screw an place this a hole up or down;
- Fasten the calf plate again with the allen key;
- Make sure the calf plate is in the right position.

5.6 Using the wheelchair brake

Putting the wheelchair brake on
If you are in the wheelchair.
-
Take the black handle of the brake, see figure 10;
-
Push the lever forward until you hear the click, this confirms that the wheelchair has been put on the parking
brake.
If you are next to the wheelchair.
-
Go to the side of the wheelchair and face towards the front of the wheelchair;
-
Take the black handle of the brake;
-
Push the lever forward until you hear the click, this confirms that the wheelchair has been put on the
parking brake.

5.7 Using the armrest

Flipping the armrest backwards
If you are in the wheelchair.
- Where the front of the armrest meets the frame you will find a black lever. Pull the black lever to the
frame, see figure 11;
- You can now swing the armrest backwards because it will be attached to the frame at only one point at the
rear of the armrest;
- To put the armrest back in place you must reverse the previous steps. Please make sure you hear the click
that confirms that the armrest is back in place.
Figure 11
~ 16 ~
Overall user manual
Figure 10