Wheels (Tyre Table); Using Accessories And Other Options On Your Wheelchair - 2GOability Infineon XS5000 User Manual

5.8 Wheels (tyre table)

Removal of the rear wheel
You can remove the rear wheels using the quick release system in the following way:
- Stand next to the wheelchair;
- Tilt your wheelchair slightly so the wheel you wish to remove is slightly off the ground;
- Press the black button in the centre of the wheel (figure 12) and remove the axle and wheel from the
frame. Make sure the black button is completely pressed in;
To put the rear wheel back in place you must reverse the above steps. In order to ensure your safety please make
sure the axle is fully in place and the ball bearing system is engaged so the wheel does not come loose during use.
Tyre table
Wheelchair model Rear
wheel
INFINEON® Self propel
XS 5000
5.9

Using accessories and other options on your wheelchair

The seat cushion (optional item)
Your wheelchair can be equipped with a 5 cm thick, nylon seat cushion. This seat cushion is equipped with an anti-
skid layer, see figure 13. You need to place the seat cushion with the anti-slip side down on your wheelchair. When
you are going to sit in the wheelchair the seat cushion will not move.
Figure 12
Tire size Maximum pressure rear
rear tires
24" x 1 3/8" 4,5 bar / 65 psi
24" x 1" 7,5 bar / 110 psi
~ 17 ~
Figure 13
Overall user manual