Troubleshooting - pro.point 18 GAUGE AIR BRAD NAILER User Manual

18 gauge air brad nailer
Table of Contents

Advertisement

Available languages

Available languages

8344624
TROUBLE SHOOTING
The following form lists the common operating system with problem and solutions. Please read the
form carefully and follow it.
WARNING: If any of the following symptoms appears during your operating, stop using the tool
immediately, or serious personal injury could result. Only a qualified persons or an authorized
service center can perform repairs or replacement of tool.
SYMPTOM
Air leak near top of the
tool or in trigger area.
Air leak near bottom
of tool.
Air leak between body
and cylinder cap.
Blade driving fastener
too deep.
Tool does not operate
well; cannot drive
fastener or
operates sluggishly.
Tool misfires.
Visit www.princessauto.com for more information
18 GAUGE AIR BRAD NAILER
PROBLEM
1. O-ring in trigger valve
is damaged.
2. Trigger valve head
is damaged.
3. Trigger valve stem, seal or
O-ring is damaged.
1. Loose screws.
2. Worn or damaged O-rings
or bumper.
1. Loose screws.
2. Worn or damaged O-rings
or seals.
1. Worn bumper.
2. Air pressure is too high.
1. Inadequate air supply.
2. Inadequate lubrication.
3 Worn or damaged O-rings
or seals.
4. Exhaust port in cylinder
head is blocked.
1. Worn bumper or
damaged spring.
2. Dirt in front plate.
3. Dirt or damage prevents
fasteners from moving
freely in magazine.
4. Worn or dry O-ring on
piston or lack
of lubrication.
5. Cylinder cover seal
is leaking.
SOLUTIONS
1. Check and replace O-ring.
2. Check and replace trigger
valve head.
3. Check and replace trigger valve stem,
seal or O-ring.
1. Tighten screws.
2. Check and replace O-rings
or bumper.
1. Tighten screws.
2. Check and replace O-rings or seals.
1. Replace bumper.
2. Adjust air pressure.
1. Verify adequate air supply.
2. Place 2 to 4 drops of oil into air inlet.
3. Check and replace O-rings or seals.
4. Replace damaged internal parts.
1. Replace bumper or pusher spring.
2. Clean drive channel on front plate.
3. Magazine needs to be cleaned.
4. O-ring needs to be replaced
and lubricated.
5. Replace sealing washer.
V 3.03
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents