Advertisement
Scenario Descriptions
Scenario 3
Existing DHCP Server on the
LAN
If your LAN uses an existing DHCP server, complete
the following steps to get Internet access through the
DSL or cable modem.
Connect a PC directly to the Router
1 Use the provided blue cable to connect a PC to the
router’s LAN 1 port. You must temporarily
remove this PC from the network.
2 On the back of the router, set the Hub/PC switch
to “PC”.
3 Configure the PC to obtain an IP address from a
DHCP server. See the documentation that came
with your PC for instructions on this setting.
4 Restart your PC; otherwise you will not be able to
contact the router.
Disable the DHCP server on the router
1 If it is not already open, start Intel
2 In the Discovered Device Tree, expand the Subnet
192.168.1 (see Figure 11).
3 Double-click on 192.168.1.1 (the default IP
address for LAN 1).
4 From the Configuration menu, select DHCP
Server Setup.
5 Clear the Enable DHCP Server check box.
6 Click OK.
®
Device View.
Internet
DSL/cable modem
Input
5.1VDC/2.6A
Recovery
Power
7070
Figure 10. Connect a PC directly to the router.
Figure 11. Open the router for management.
Figure 12. Disable the router's DHCP server.
PC
Console
Hub
PC
II
X
WAN
LAN 1
LAN 2
MAC
00AA00D1865D
CASE
123456 789
10 Mbps
10 / 100 Mbps
ADDRESS
ASSY
Set this switch to "PC"
7
Advertisement
