Memory Configurations; Expansion Slots - Asus Motherboard P4PE BP User Manual

1.9.1 Memory configurations

You may install any DDR DIMMs with 64MB, 128MB, 256MB, 512MB, and 1GB
densities into the DIMM sockets.
Use only the following combinations to install DDR DIMMs. Otherwise, the
system may not boot up.
DDR DIMM1
(Rows 0&1)
SS/DS
SS/DS
*
SS - Single-sided DIMM
DS - Double-sided DIMM
1. DDR DIMM sockets 2 and 3 share the same rows, so if you install a
2. You may install single-sided DIMMs into DIMM2 and DIMM3 sockets at the
3. Double-sided x16 DDR DIMMs are not supported on this motherboard.

1.10 Expansion slots

The motherboard has three PCI slots and one Accelerated Graphics Port (AGP) slot.
To install and configure an expansion card:
1. Install an expansion card following the instructions that came with the chassis.
NOTE: The AGP slot supports only 1.5V AGP cards.
2. Turn on the system and change the necessary BIOS settings, if any. See
Chapter 2 for BIOS information.
3. Assign an IRQ to the card. Refer to the tables below.
4. Install the drivers and/or software applications for the expansion card
according to the card documentation.
1-14
DDR DIMM2
(Rows 2&3)
DS
SS
double-sided DIMM into DIMM2 socket, you must leave DIMM3 socket
empty.
same time but neither one can be x16 DDR module.
DDR DIMM3
(Rows 3&2)
None
SS
Chapter 1: Product introduction