Temperature Control - GE Thinline AJH06 Use And Care Manual

Temperaturecontrol
When you turn TE~ERATURE
control to desired setting, thermo-
stat will automatically control the
temperature of the indoor air. The
higher the number selected, the
cooler the indoor air will be; the
lower the number, the warmer the
indoor air.
Mr
Exchanger
When this control is set at "closed;'
only the air inside the room can be
circulated and conditioned. When
it's in the "open" position, some
indoor air can be exhausted from
the room.
selector switch
OFfi turns air conditioner off.
HI FAN permits high fan
speed operation without cooling
or heating.
LO FAN permits low fan
speed operation without cooling
or heating.
HI COOL permits cooling with
high fan speed operation.
LO COOL permits cooling with
low fan speed operation.
HI HEAT permits heating with
high fan speed operation.
LO HEAT permits heating with
low fan speed operation.
-.
FOF normal cooling
1. Set SELECTOR switch at HI
COOL.
2.
Set TEMPERATURE control at
desired number (usually the nlid-
point is a good starting position). If
room temperature is not satisfactory
after a reasonable time, set the tem-
perature control at a higher number
for a cooler room or at a lower numb-
er for a warmer room.
3. Set AIR EXCEIP=IVGER control
al ..c[osed" position.
,< ~
For
maximum
cooling
i
)
1. Set SELECTOR switch at HI \
COOL.
I
/
2. Set TE~ERATURE control
at 10.
\
3.Set AIR EXCMNGER
control
at "closed" position.