GE Thinline AJC06 Use And Care Manual page 5

s.
.,.
1
.,.
f-
-.
\
~
'-—..
"
I
1. Set SELECTOR switch at HIGH
COOL.
2. Set TEIWERATURE control at
desired number (usually the mid-
point is a good starting position). If
room temperature is not satisfactory
after a reasonable time, set the tem-
perature control at a higher number
for a cooler room or at a lower num-
ber for a warmer room.
1. Set SELECTOR switch at HIGH
COOL.
2. Set TEMPERATURE control
at 10.
3e Set AIR EXCHANGER control
at "closed" position.
4. Slide ENERGY SAVER switch
to "normal."
For
quieter operation
1. Set SELECTOR switch at LOW
FM speed position.
2. Set TE~ERATURE control at
desired number.
3. Set AIR EXCHANGER control
at "closed" position.
4, Slide ENERGY SAVER switch
to desired position —"save" or
"normal."
I>uring the co~>lcrevening hours,
it is rccommencfecl that
yoLI set
the SELECTOR at LOW COOL
[()].Vci-y~]uiet(Jper:l{ionand the
TENIPERATURE c~)ntrol at n~id-
':~ngc(5 or (>).
Whether controls are set for cool-
ing or fan operation only, setting
the Air Exchanger control at "open"
lets room air be exhausted to the
outside. This is helpful in removing
stale air, smoke or odors from the
room, and permits outdoor air to en-
ter through normal openings in the
house. However, cooling effective-
ness is reduced when this control
is set at "open;' so we suggest you
don't keep it there long–especially
in hot, humid weather.
To
adjust
air
&reetion
SIDE-TO-SIDE AIR DIRECTION
The
side-to-side
air t irection
]OW~e~S are cOntrO]iedby tab$ that
let you position the louvers to dis-
charge air to the left, to the right,
c>rstraight ahead.
To reverse air direction:
1. Remove front grille.
Press grille downward and pull top
toward you to release grille from
catches-at top. Lift gri[le off.
2. Push down on the air deflector
tab and pull
deflector out.
4 B
3. Turn deflector
around and reinsert
it with tab at top.
For straight out air discharge,
remove air deflector from grille.