GE JTP44 Use And Care Manual page 24

How to Set Oven for Cleaning
Quick Reminder:
1. Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the AUTO SELF CLEAN pad.
4. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
the word "OFF" will appear in the display. Allow
additional time for cooling before you try to set
the cycle.
NOTE: Only one oven at a time can be self-cleaned.
1. Follow directions to prepare the oven for cleaning.
CLEAN
3. Press the INCREASE or DECREASE
pad until the desired Clean Time
is displayed.
Clean Time is normally 3 hours.
You can change the Clean Time to
anytime between 2 and 4 hours,
depending on the amount of soil in
your oven.
To Stop a Clean Cycle
o
1. Press the CLEAWOFF pad.
CLEAR
OFF
24
(continued)
The self-clean cycle will automatically begin after
"Clean" is displayed and the time for the Clean
cycle is set. The words "ON" and "LOCK" will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK light goes off.
4. When the LOCK light is off, open the door.
NOTE:
.
You can find out when the clean cycle
TIME pad.
A
"LOCK" will flash and oven c~ntrol will signal
if you set the clean cycle and forget to close the
oven door.
fan may automatically turn on and off to cool
A
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
2. Wait until the oven has cooled below locking
temperature. You
door right away unless the oven has cooled below
the locking temperature.
will not be able to open the