GE JTP44 Use And Care Manual page 18

How to Set the Oven When Using the Temperature Probe
The display will flash "PROBE" and the oven
control will signal if the probe is inserted into
the outlet, but the oven is not programmed for
the probe.
1. Insert the probe
into the meat.
2. Plug the probe
into the outlet
in the oven.
Make sure it's
pushed all the
way in. Close
the oven door.
Press the PROBE pad.
3.
PROBE
UPPER OVEN
4. Press the INCREASE or DECREASE
pad. The last oven set temperature
appears in the display. Continue pressing
until the desired oven tem~erature is
displayed.
6. Press the INCREASE or DECREASE
pad until the desired internal probe
temperature is displayed.
The oven will start automatically. The words
"BAKE ON" and the roasting temperature you
set will be in the display.
After a few seconds, the words "LO PROBE" will
replace the roasting temperature in the display.
After the internal temperature of the meat reaches
shown in the display.
ROASTING WITH THE PROBE
(continued)
.
o
7. When the internal temperature of meat
reaches the number you have set, the
CLEAR
probe and the oven turn off and the oven
OFF
control signals. To stop the signal. press
the CLEAR/OFF pad. Use hot pads to
remove the probe from the food. Do not
use tongs to pull on it–they might
damage it.
CAUTION: To prevent possible burns, do not
unplug the probe from the outlet until the oven has
cooled. Do not store the probe in the oven.
NOTE:
final temperature is reached, a tone will sound and
the display will flash until the probe is removed
from the oven.
You will not be able to use the probe in the upper
oven during timed oven operations. This is because
with the probe you are cooking by temperature
rather than time.
You can use the timer even though you cannot use
timed oven operations.
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
To change the oven temperature during the
Roast cycle, press the BAKE pad and then
the INCREASE or DECREASE pad to get the
new temperature..