GE JTP44 Use And Care Manual page 25

You may
notice some white ash in the oven. Just wipe
i [ up with a damp cloth after the oven cools.
remove them with a soap-filled
steel woo] pad. sure to rinse thoroughly with
Be
a vinegar and water mixture. These deposits are
usually a salt residue that cannot be removed by the
clean cycle.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Prepare the oven for cleaning.
2. Close the oven door completely.
3. Press the AUTO SELF CLEAN pad.
4. Press [he INCREASE or DECREASE pad until
the desired Clean Time appears.
5. Press the STOP TIME pad.
6. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow steps to prepare the oven for cleaning.
Press the AUTO SELF CLEAN pad.
2.
AUTO SELF
CLEAN
3. Press the INCREASE or DECREASE
pad to enter the Clean Time.
the cycle.
If the shelves have become hard to slide, wipe the
shelf supports with cooking oil.
NOTE: No functions can be programmed before the
door automatically unlocks.
4. Press the STOP TIME pad. "SET STOP
STOP
TIME" and the earliest Stop Time you
TIME
can set will appear in the display.
The earliest Stop Time will be the Clean Time
selected plus the time of day. For example: If the
Clean Time is three hours and the time of day is 6:00,
the Stop Time that appears in the display will be 9:00.
5. Press the INCREASE pad to change the Stop Time
to a later time of day if desired. For example:
clean cycle at 8:00 and end at 11 :00. The door
latches automatically.
The self-clean cycle will automatically begin
after "CLEAN" is displayed and the time for the
Clean cycle is set. The words "ON" and "LOCK"
will appear in the display when the door
automatically locks. It will not be possible to open
the oven door until the temperature drops below the
lock temperature and the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
During a delayed self-clean operation you can find
out when the oven is set to turn on by pressing and
holding the CLEAN pad for 3 seconds.
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
25