Record And Snapshot; Encode - Panasonic k-nl304g User Manual

Call Tour
In Figure 4-30, input tour value and then click
Call Scan
In Figure 4-30, input autoscan value and then click
call.
Autopan
In Figure 4-30, click
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:

Preset, tour and pattern all need the value to be the control parameters. You can define it as you
require.

You need to refer to your camera user's manual for Aux definition. In some cases, it can be used for
special process.
Aux
Click , system goes to the following interface. The options here are defined by the protocol. The aux
number is corresponding to the aux on-off button of the decoder. See Figure 4-36.

4.7 Record and Snapshot

The record/snapshot priority is: ALARM->MOTION DETECT->SCHEDULE.

4.7.1 ENCODE

4.7.1.1 ENCODE
Encode setting is to set IPC encode mode, resolution, bit stream type and etc
From Main menu->SETTING->REMOTE->ENCODE, you can see the following interface. See Figure
4-37.
to enable the camera to rotate.
Figure 4-36
to call a tour. Click again
to call a tour. Click again
to stop call.
to stop
40