Table of Contents
Advertisement
6.
Serial ATA connectors (7-pin SATA1 [red], SATA2 [red], SATA3 [red], SATA4 [red],
SATA5 [black], SATA6 [black])
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
and optical disk drives. The Serial ATA 3Gb/s is backward compatible with Serial ATA
1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster than the
standard parallel ATA with 133 MB/s (Ultra DMA133).
If you install Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 5,
RAID 0+1, and JBOD configuration through the onboard controller.
M3N78-CM
M3N78-CM SATA Connectors
Install the Windows
• For detailed instructions on how to configure RAID 0, RAID 1, RAID 5, and
RAID 10, and JBOD, refer to the RAID manual in the support DVD.
• If you intend to create a Serial ATA RAID set using these connectors, set
the SATA Mode select item in the BIOS to [RAID Mode]. See the page
2-11 for details.
• Due to the chipset's limitation, SATA 5 and SATA 6 do not support IDE
mode, only support AHCI and RAID mode.
Chapter 1: Product introduction
R
XP Service Pack 1 before using Serial ATA.
®
GND
GND
RSATA_RXN6
RSATA_RXN5
RSATA_RXP6
RSATA_RXP5
GND
GND
RSATA_TXN6
RSATA_TXN5
RSATA_TXP6
RSATA_TXP5
GND
GND
GND
GND
RSATA_RXN3
RSATA_RXN4
RSATA_RXP3
RSATA_RXP4
GND
GND
RSATA_TXN3
RSATA_TXN4
RSATA_TXP3
RSATA_TXP4
GND
GND
GND
GND
RSATA_RXN2
RSATA_RXN1
RSATA_RXP2
RSATA_RXP1
GND
GND
RSATA_TXN2
RSATA_TXN1
RSATA_TXP1
RSATA_TXP2
GND
GND
1-21
Advertisement
Table of Contents
