Haier DW-8888-22 Service Manual page 18

6) Press the "START/PAUSE" button once to start the wash process. Press this button
once again if you want to "Pause" the activity during the wash process in order to
add or remove items.
Note: Selected wash program and option(s) blinking light(s) will indicate that the
wash process has begun and is running. When paused, the selected wash program
and option(s) light(s) will be still. This indicates that wash process is paused.
7) At the end of the wash program, the machine will beep a few times to indicate
that the wash process has finished. Simply shut off the unit by pressing the "POWER"
button.
Note: DO NOT open the dishwasher door immediately because the moist hot air
remaining inside the tub may cause harm.
Warning: Keep children away from the machine when the door is left to dry the
dishware because the moist hot air is exiting out of the door may cause harm.
Canceling or Resetting Wash Cycle
Note: The dishwasher will automatically release detergent within a few minutes after
the start of the wash program. To avoid the "release of detergent" before you cancel
or reset the wash program, you must press the "START/PAUSE" button right away
• Once you have reset to a new wash cycle, you must refill the detergent
compartment if it is open and empty because the detergent from previous wash cycle
may have already been released.
Follow the steps below to cancel or reset a wash program:
1) Press "START/PAUSE" button to pause the wash program.
2) Turn "OFF" the dishwasher power by pressing the "POWER" button to cancel the
program.
3) Turn the dishwasher back "ON" again by pressing the "POWER" button.
4) Reset by reselecting the proper wash program.
5) Reselect the proper wash option(s) with the selected wash program.
6) Press the "START/PAUSE" button to begin the wash process.
Pausing a Wash Program:
If you need to pause in the middle of the cycle to add or remove any items, follow
the steps below:
1) Press the "START/PAUSE" button to pause the wash process during the program.
When the wash process is paused, the selected wash program and option(s)
indicator light(s) will stay still.
2) Open the door by squeezing the door latch slowly.
Note: DO NOT open the door until the water spray action has stopped. Be careful of
moist hot air that may rise out of the dishwasher.
3) Add or remove items. Once you are finished adding or removing, simply close the
door properly.
4) Press "START/PAUSE" to resume the program. You will notice that the power
indicator display light turns on.
18