Intended Use; Legal - Dimplex A8M Installation Manual

1.3 Intended Use

This product is designed to extract heat from outside air to provide energy for a water-based heating
system, and is intended for domestic and light commercial use. Any other use beyond that intended by
the manufacturer is prohibited. This requires the user to abide by the manufacturer's product information.
Please refrain from tampering with or altering the device.
NOTE: Additional heating may be required if the heat pump is intended to dry out a new or renovated
building, as the initial heat load may be higher than the design load.

1.4 Legal

The construction and design of the heat pump complies with all relevant EU directives (see CE declaration
of conformity in Appendices section).
When connecting the heat pump to the power supply, the relevant EN and IEC standards must be adhered
to. Any further connection requirements stipulated by the network operation must also be observed.
When connecting to the heating system all applicable regulations must also be adhered to.
NOTE: Products not installed with the Dimplex hydraulics packs will not be supported by Dimplex. This
includes but is not limited to thermal stores.
NOTE: Installation and any service work on the heat pump may only be performed by an authorised and
qualified installer and after-sales service technicians.
Millbrook House, Grange Drive, Hedge End, Southampton, SO30 2DF
8
0844 879 3587
dimplex.co.uk | gdcgroup.co.uk