Table of Contents
Advertisement
Features available
Easy playback
Automatic input switching - When the connected equipment is operated, input mode is switched
automatically.
Power on link
Set Power on Link "On" in the Setup Menu to use this function
When the connected equipment starts playback or direct navigator / function menu for the equipment
are activated, the TV is automatically turned on. (Only when the TV is in Standby mode.)
Power off link
Set Power off Link "On" in the Setup Menu to use this function
When the TV is set to Standby mode, the connected equipment is also automatically set to Standby.
●
This function will work even if the TV enters standby mode automatically by auto power standby
function.
Reduce unnecessary power consumption in standby
Standby Power Save
Set Standby Power Save "On" in the Setup Menu to use this function
"Standby Power Save" (p. 26)
The power consumption in Standby mode of the connected equipment is controlled higher or lower
in synchronization with the TV On / Off state to reduce the consumption.
When the TV is set to Standby mode, the connected equipment is automatically set to Standby and
the power consumption in Standby mode of the connected equipment is automatically minimized.
When the TV is turned on, the connected equipment is still in Standby mode, but the power
consumption is increased to make startup time early.
●
This function is effective if the connected equipment can change the power consumption in
Standby mode and is set to higher consumption.
●
This function will work when "Power off Link" is set to "On".
Intelligent Auto Standby
Set Intelligent Auto Standby "On (With reminder)" or "On (No reminder)" in the Setup Menu
to use this function
"Intelligent Auto Standby" (p. 26)
When the TV is On, non-watched or non-used connected equipment goes into Standby mode
automatically to reduce the power consumption. For example, when the input mode is switched from
HDMI, when Speaker Selection is changed to "TV" (except for watching a disc).
●
If you select "On (With reminder)", the on screen message will be displayed to be noticed before
working this function.
●
This function may not work properly depending on the connected equipment. If required, set to
"Off".
Auto standby for unnecessary equipment
"Power on Link" (p. 26)
"Power off Link" (p. 26)
45
Advertisement
Table of Contents
