Furnace Installation - Golden Eagle 7000 Owner's Installation And Operation Manual

INSTALLATION OPTIONS
The installation of this furnace includes supplying electrical power, return (fresh air) ductwork, and supply air ductwork. This furnace
may be installed in three different confi gurations.
1) Stand alone wood furnace
2) Add-on wood furnace
The furnace also has several additional kits that may be installed.
• GE7B - Blower Kit (Required)
• GE7FAK - Fresh air Kit (Optional)
• GE7CAP - Cold Air Plenum (Optional)
See kit installation section in this manual and as supplied with your kits to ensure proper assembly, installation and operation of your
new furnace.
If installing in an area with a fan it should not be allowed to create negative pressure in the room where the furnace is installed.
LOCATING YOUR FURNACE
Your furnace must be installed as shown in this manual and in compliance with all local and national codes.
It is of the utmost importance that the clearances to combustible materials be strictly adhered to during installation of the furnace.
Refer to the table and diagrams below for minimum required clearances.
Dimension
A Backwall to Furnace
B Sidewall to Furnace
C Sidewall to Flue
D Backwall to Flue
E Supply Duct (fi rst 6 feet)
F Supply Duct (after fi rst 6 feet)
G Minimum Duct height
Ceiling / Plafond
E
G
Floor Protector / Protection de Plancher
CLEARANCE TO COMBUSTIBLES

FURNACE INSTALLATION

(INSURE THAT THE REQUIRED MAINTENANCE CLEARANCES ARE MAINTAINED)
Inch mm
29 737
10 254
18 458
18 458
6 153
1 26
8 204
F
D
Back wall / Arrière Mur
A
B
CLEARANCE TO COMBUSTIBLES
C