Advertisement
starts to blink. (Differs depending
on the use situation.)
A full charge will supply enough
power for approx. 14 shaves (3 min-
utes per shave for a normal beard).
Before travelling, charge it fully for
1 hour if you will not be taking the
adaptor with you.
In case your shaver is without
charge, you may quick charge it for
1 shave in about 5 minutes.
Cord shaving
Connect the shaver to the power
cord and plug the adaptor to the AC
outlet, then turn the shaver on.
If the shaver does not run, charge it
for approx. 1 minute.
Using your shaver
Caution – The system outer foil is
very thin and can be damaged if
handled improperly. Before each
use, always check the foil for
damage. To avoid personal injury,
do not use if the foil or other parts
of the shaving head is damaged.
Push the 0/1 switch to turn the
shaver on.
If you push and hold the 0/1 switch
for more than 2 seconds, it will
activate the turbo mode for "sonic"
vibration cleaning.
(see "Cleaning your shaver")
Caution:
Shaving with "sonic" vibration may
damage your skin. Please turn it
off and on again to deactivate the
turbo mode.
Do not place fingers on the 0/1
switch during use.
This may cause the shaver to stop
during use or change it to the
"sonic" vibration cleaning mode.
Hold the shaver at a right angle
(90°) to your skin (see fig. 4). Start
out shaving by applying gentle
pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the
direction of your beard. You may
gently increase the amount of
pressure as your skin becomes
accustomed to this shaver. Applying
excessive pressure does not
provide a closer shave.
System outer foil
(see fig. 5)
System outer foil has a slit blade (a)
between 2 foils (b). They move up
and down independently to follow
the contours of your face.
The slit blade catches and cuts
longer and lying hairs easily.
7
Advertisement
