Download Print this page

Panasonic ES8801 Operating Instructions & Cook Book page 10

Ac/rechargeable shaver

Advertisement

the rechargeable battery for the
purpose of proper disposal.
1. Disconnect the power cord from
the shaver when removing the
battery.
2. Remove the back panel screw
(a).
3. Remove the trimmer (b).
4. Slide the back panel (c) and
remove it.
5. Remove the side panels (d).
6. Remove the three housing
screws (e).
7. Remove the housing (f).
8. Lift the battery (g) and remove it.
Caution
• Do not charge the shaver, where it
will be exposed to direct sunlight or
a heat source, or where there is a
lot of moisture.
• Use only the included adaptor
RE7-27 to charge the ES8801
shaver.
• Dry the shaver completely before
charging it.
• The shaver and adaptor will
become slightly hot during use or
charging, however this is not a
malfunction.
• Keep the adaptor away from water
and handle it only with dry hands.
• Grip the adaptor when disconnect-
ing it from an AC outlet; tugging on
the power cord may damage it.
• Store the adaptor in a dry area
where it will be protected from
damage.
• Do not pull, twist, or severely bend
the power cord.
• Do not wrap the power cord tightly
around the appliance.
• If the power cord gets damaged, it
alone can not be replaced.
Contact an authorized service
center.
• In cases where static noise is
emitted from the television during
use or recharging, connect the
adaptor to a different outlet.
• Do not touch the edge (metal part)
of the inner blade.
Failure to observe this may lead
to hand injuries.
• Wash the shaver in tap water. Do
not use salt water or boiling water.
Also, do not use cleaning products
that are designed for toilets,
bathrooms or kitchen appliances.
Do not submerge the shaver for a
long time.
• Do not wipe any part of the shaver
with thinner, benzine or alcohol.
Clean it by using a cloth dampened
with soapy water.
• Do not take the housing apart as
this can affect the watertight con-
struction.
• Do not clean with water when the
shaver is connected to the power
cord.
• When cleaning the shaver with
water, do so with both the inner
blades attached. (Doing so with
only one of the inner blades
attached makes an abnormal noise
and may damage the shaver.)
10

Advertisement

loading