Leveling And Door Alignment - LG MFL37933590 Owner's Manual

LEVELING AND DOOR ALIGNMENT

Leveling
After installing, secure the product with the LEG
not to move left or right.
Your refrigerator has two front leveling screws—
one on the right and one on the left. If your
refrigerator seems unsteady or you want the
doors to close easier, adjust the refrigerator's tilt
using the instructions below:
1. Plug the refrigerator's power cord into a
3-prong grounded outlet. Move the refrigerator
into its final position.
2. Turn the leveling leg clockwise to raise that
side of the refrigerator or counterclockwise to
lower it. It may take several turns of the
leveling leg to adjust the tilt of the refrigerator.
NOTE: Having someone push against the top
of the refrigerator takes some weight off the
leveling legs. This makes it easier to adjust the
legs.
3. Open both doors again and check to make
sure that they close easily. If not, tilt the
refrigerator slightly more to the rear by turning
both leveling screws clockwise. It may take
several more turns, and you should turn both
leveling screws the same amount.
4. Re-adjust if necessary.
5. Replace the base cover.
NOTE: Your new refrigerator is uniquely
designed with two fresh food doors. Either door
can be opened or closed independently of one
another. You may have to exert slight pressure
on doors to get them to close completely.
REFRIGERATOR INSTALLATION
Door Alignment
If the space between your doors is uneven, follow
the instructions below to align the doors:
1. With one hand, lift up the door you want to
raise at middle hinge.
2. With other hand, use pliers to insert snap ring
as shown.
3. Insert additional snap rings until the doors are
aligned. (Three snap rings are provided with
unit.)
w CAUTION
• To avoid possible injury or product or property
damage, you will need two people to perform
the following instructions.
Level the refrigerator by using an 11/16 inch
(18mm) wrench or a flat blade screw driver.
Turn the leveling legs (CCW) to raise or (CW) to
lower the height of the front of the refrigerator.
NOTE: The front of the refrigerator should be
slightly higher than the back.
NOTE: If someone pushes backward against the
top of the refrigerator, weight is lifted off of the
leveling legs, which makes adjustment easier.
Open both doors to make sure they close easily.
If not, raise the leveling legs higher by turning
both clockwise the same amount. Once the
refrigerator is level, replace the kick-plate.
NOTE: Your new refrigerator is uniquely
designed with two fresh food doors. Either door
can be independently opened or closed.
You will have to exert slight pressure on the
doors to close them completely.
NOTE: In order not to move the refrigerator back
and forth, fix it with the 'Adjust' to the floor to
install and use.
18