Table of Contents
Advertisement
AREA REQUIREMENTS
Verify the following:
• Unit can fit into residence
and can be moved
around
corners
and through
doorways.
• Floors
can support
unit's weight
plus food
weight
(approximately
1200 pounds
[540 kg] total).
• Rear wall is solid and is able to support
two (2) horizontally
mounted
2X4s (included)
bolted
to 2 wall studs.
board
bolt heads must be flush with 2X4 to prevent
obstruction.
• Remove
anything
attached
to rear or side walls that can obstruct
unit installation.
• Cutout
dimensions
are accurate.
• Electrical
outlet
is in correct
location.
• Water
line is in correct
location
(All Freezer
only).
The 2X4
ELECTRICAL REQUIREMENTS
l!_0
!
ELECTRICAL SHOCK HAZARD
Plug into a grounded 3-prong outlet.
DO NOT remove ground plug.
DO NOT use an adapter.
DO NOT use an extension cord.
Failure to follow these instructions could result in
fire or electrical shock.
If codes permit a separate grounding
wire to be
used, it is recommended
that a qualified electrician
determine that the grounding
path is adequate.
Do Not ground to a gas pipe.
Check with a
qualified electrician if you are not sure the
appliance is properly grounded.
Do Not have a
fuse in the neutral or grounding
circuit.
It is the customer's responsibility
to:
•contact a qualified electrical installer.
•assure that the electrical installation is adequate and in conformance with the
National Electrical Code, ANSI/NFPA 70-latest edition or Canadian Electrical
Code C22.1-1998 and C22.2 No. 0-M91 (or latest edition), and all local
codes and ordinances.
(115 volt, 60-Hz, 15 amp, fused, electrical supply is
required.
It is required that a separate circuit serving only this appliance be
provided.
This appliance is equipped
with a power supply cord having a 3-
prong grounding
plug. To minimize possible shock hazard, the cord must be
plugged into a mating 3-prong, grounding-type
wall receptacle.
Do not use
an extension cord.)
3-PRONG GROUNDING
TYPE
WALL RECEPTACLE
3-PRONG
Anti-Tip
Requirements
The anti-tip boards should be fastened
into position prior to moving the unit into
the openin 9.
Note:
Additional
mounting
boards
may
be required
if the unit does not touch
the back wall of the enclosure.
To
prevent
unit from tipping
forward,
it
must be secured
in place with a solid
soffit
or wood
block.
TIP OVER HAZARD
Appliance is top heavy and tips easily when not
o_
llcompletely installed.
Keep doors closed until appliance is completely
installed and secured per installation instructions.
Use two or more people to move and install
appliance. Failure to do so can result in death or
serious injury.
16
Advertisement
Table of Contents
