Table of Contents
Advertisement
within the front wheel. The greater you press down the left thumb control, the
greater the braking force applied. The electronic brake slowly stops the scooter.
Apply the emergency brake for faster stops.
d. Horn <Figure D>
Turn on the power, press the horn button and it will sound.
e. LED Headlight <Figure D>
Press the red LED headlight button to turn the light on. The display will indicate the
light is turned on. Press the LED headlight button again to turn the light off. Do
not operate the scooter at night or in conditions of poor visibility.
f. Display
-When power is off, the display shows the time.
-When power is on, the display has three modes: total, trip and time. You can press
the mode button to change it. When it displays the 'trip' mode, press the setting
button for 3 seconds and it will reset the trip.
-To set the time, press the power button on, then press the setting button for 3
seconds-12 hr or 24 hr will begin to flash, use the mode button to select either 12 or
24 hour time, press the setting button to toggle next to set the hour, use the mode
button to select the correct hour, use the setting button to toggle next to set the
minutes, use the mode button to select the correct minutes. When the time is set,
press the setting button a final time.
g. Emergency Brake
For quick stops or additional braking force, push the rear foot friction brake.
Applying the rear friction brake also engages the front wheel electronic magnetic
brake. Please note, applying the rear friction brake under high speeds may damage
the rear wheel. The manufacturer will not be responsible for this damage.
3. Display Factory Setting for Kilometers or Miles.
Press setting button and mode button at the same time for 3 seconds.
Four
numbers will flash at the bottom right of display. Press the setting button to change
the number location and press the mode button to change the number from 0-9.
Advertisement
Table of Contents
