Table of Contents
Advertisement
•
•
Triggered Action (Multi-option)
The Administrator can specify alarm actions that will take when motion is
detected. All options are listed as follows:
•
•
•
•
42
Sensitivity level [1-100]:
The default level is 80, which means if 20% or more sampling pixels are
detected differently, system will detect motion. The bigger the value, the
more sensitive it is. Meanwhile, when the value is bigger, the red
horizontal line in the motion indication window will be lower accordingly.
Time interval (sec) [0-7200]:
The default interval is 10. The value is the interval between each
detected motion.
Enable Alarm Output
Check the item and select the predefined type of alarm output to enable
alarm relay output when motion is detected.
NOTE: This option is excluded in the Compact IP Dome
Camera.
Record stream to SD Card
Select this item, and the Motion Detection recording will be stored in
Micro SD/ SDHC card when motion is detected.
NOTE: Please make sure the local recording (with Micro SD/
SDHC card) is activated so that this function can be implemp-
lemented. See section
Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by
FTP and/or E-Mail when motion is detected.
Upload Image by FTP
Select this item, and the Administrator can assign a FTP site and
configure various parameters as shown in the figure below. When
motion is detected, event images will be uploaded to the appointed FTP
site.
4.3.10 Recording
for further details.
Advertisement
Table of Contents
