Advertisement
GSF Primeline 6
Programme selector knob
On / Off button
Start button
Switches "on" when the dishwasher is operating.
Flashes when a fault occurs. Switches off at the end
of the programme.
Indicators
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Add rinse aid
Programmes
AutoSensor
Pre-Rinse
Glasses
Rapid 30 min
1) 5)
Eco
Intensive
1)
Reference programme for energy label EN 50242;
2)
Refer to "User instructions";
3)
The data relevant to programmes are values obtained in the
laboratory in conformity with Standard EN 50242. In practice
there may be time variations or leaps depending on different
loads, function options, sensor calibration (only for sensor-
controlled programmes) water temperatures or hardness and
different power supply voltages.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: "nk_customer@whirlpool.com".
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Programme chart
Loading instructions
Automatic programme
recommended for routine washes,
5)
50-65°C
with no dried-on or burnt food (not
for EN 50242).
cold
Crockery to be washed later.
Light soiling, for example glasses and
40°C
cups.
Lightly soiled crockery with no
40°C
dried-on food.
50°C
Normally soiled crockery.
Recommended programme for
5)
70°C
heavily soiled crockery, especially
suitable for pans and saucepans.
3)
Options
Time and failure display
Indicates in hours the time remaining until the start
of the wash cycle. Switches off when the
programme starts and indicates the time remaining
in hours and minutes.
"F ...." Identification of faults for service technician
"Delayed start" button
The wash cycle can be programmed to start after
1 - 24 hours. With each successive touch of the button,
the delayed start indicator increases by 1 hour, and
after 24 returns to 00. Then press the Start button.
The dishwasher will start at the set time.
Antibacterial rinse
This function adds an antibacterial rinse at the end of the
wash cycle, thereby guaranteeing a perfectly clean and
sanitized load. The lamp will light up when the function is
activated. If the temperature is not maintained during
the antibacterial cycle (e.g. if the door is opened and
remains open for a long time), the lamp will start blinking
to indicate that sanitation is not guaranteed.
Detergent
A
X
-
X
X
X
X
4)
The bacteria removal efficiency has been tested by the Institut
Pasteur de Lille (France), based on the NF EN 13697 standard
of November 2001.
5)
These programmes can be used with the Antibacterial rinse option.
(We reserve the right to make technical modifications)
GB
4) 5)
2)
3)
Consumption
B
Litres
kWh
Minutes
X
13-19 1.15-1.50 100-130
-
5.0
0.02
10
-
13.0
0.90
97
-
13.0
0.70
30
X
16.0
1.05
170
X
17.0
1.65
145
5019 496 01534
Advertisement
