Jack Lananne's Power Juicer Elite Operating Manual page 8

POWER JUICER ELITE
Assembly
IMPORTANT: There are MIN/MAX arrow markings on the
orange rim of the filter. These markings prevent you from
overtightening or undertightening the blade. Crescent
tool should line up between MIN/MAX arrows (as shown).
CAUTION: Remove crescent tool and set
aside. Do not leave tool inside juicer.
8
Assembly/Main Unit
Main Unit
STEP
Place the pulp collector so that it rests under
the backside of the juicer.
IMPORTANT: There is a Micro Safetyswitch located
in the back center of the pulp collector base.
This mechanism is an added safety
feature. Once the pulp collector
is in place the Activating Pin on
the bottom of the pulp collector
activates the Micro Safetyswitch.
Activating Pin This will protect you from accidentally
(Bottom of
putting hands or fingers under the
pulp collector)
machine while the blade is spinning.
Once the pulp collector is removed from
the main base the motor will not run.
STEP
Place lid with built-in pulp guard on top
of receptacle, making certain it is snugly
aligned with the pulp guard facing in
the opposite direction of the juice spout.
POWER JUICER ELITE
Note: Refer to page
6 for all part names.
4
STEP :
Place blade inside filter, centered
over screw peg. Using orange
crescent tool, place its pegs
into the holes on the blade.
Turn clockwise while holding
the filter and receptacle in place
until tight (as shown).
Filter
Crescent Tool
5
:
Arrow Markings
6:
MIN/MAX
Micro
Safetyswitch
Micro
Safetyswitch