Download Print this page
Jack Lananne's Power Juicer Power Juicer Express Owner's Manual

Jack Lananne's Power Juicer Power Juicer Express Owner's Manual

Advertisement

OWNER'S
MANUAL
Please read and save
this manual.
© 2008 Tristar Products, Inc.
All rights reserved.
Distributed by:
Tristar Products, Inc.
Wallingford, CT 06494
FOR HOUSEHOLD USE.
PJExpress V4 0508

Advertisement

loading

Summary of Contents for Jack Lananne's Power Juicer Power Juicer Express

  • Page 1 OWNER’S MANUAL Please read and save this manual. © 2008 Tristar Products, Inc. All rights reserved. Distributed by: Tristar Products, Inc. Wallingford, CT 06494 FOR HOUSEHOLD USE. PJExpress V4 0508...
  • Page 2 Exciting Offers from TABLE OF CONTENTS Power Juicer Express Accessory Kit & Cookbook “Recipes for Healthy Living” Important Safety Information Cookbook Power Juicer Platform Filter Brush Overflow Platform Measuring Cup Helpful Hints Parts List Replacement Replacement Parts Kit #1 Parts Kit #2...
  • Page 3: Troubleshooting

    TROUBLESHOOTING IMPORTANT SAFEGUARDS READ THESE SAFEGUARDS CAREFULLY BEFORE USING THIS PRODUCT! Problem Possible Reasons and Solution When using electrical appliances, basic safety precautions should always The motor does not • Check to see if unit is plugged in. be followed including the following: run after being •...
  • Page 4: Cleaning

    ADDITIONAL SAFEGUARDS CLEANING YOUR POWER JUICER EXPRESS The Power Juicer has a thermal cut-off safety feature. If the unit accidentally overheats, it will stop working temporarily until the Power Juicer cools down. Afterwards, the unit will continue to work again normally.
  • Page 5: Disassembly

    DISASSEMBLY PARTS LIST IMPORTANT: Before disassembling the unit make sure you turn the power OFF and unplug the machine from the electrical outlet. Pusher Locking MAIN UNIT (Fully Assembled) Chute Pusher STEP 2: STEP 1: Pulp Lower the locking bar (silver) into position Remove pusher from the chute.
  • Page 6: Assembly

    ASSEMBLY ASSEMBLY (CONT.) Assemble as shown STEP 1: Place base on a dry flat surface with locking Lid with built-in Pulp guard bar in down position as shown. In front of the machine (spout side). Locking IMPORTANT: There is a Safety MicroSwitch Base located in the back center of the base.