Advertisement
Advertisement
Related Manuals for Jack Lananne's Power Juicer power juicer
Summary of Contents for Jack Lananne's Power Juicer power juicer
- Page 1 OPERATING MANUAL...
-
Page 2: Table Of Contents
Power Juicer 4 Helpful Hints for the Power Juicer 5 Parts List for the Power Juicer 6 Assembly for the Power Juicer 8 Disassembly for the Power Juicer 9 Cleaning Your Power Juicer 10 Troubleshooting for the Power Juicer CONTENTS... -
Page 3: Important Safeguards
Power Juicer. • Do not unfasten the locking bar during operation. • To avoid risk of injury keep hands and utensils out of the Power Juicer and away from its sharp blade during operation. • Use the pusher, not fingers or utensils, to propel the food into the Power Juicer. -
Page 4: Helpful Hints
• Let the Power Juicer run for a few minutes before turning off to allow any excess juice to be extracted from the pulp. Once turned off it is quite normal for the juicer to spin for a minute or so due to the very fine precision balancing of this appliance. -
Page 5: Parts List
Power Juicer (Fully Assembled) Power Juicer Receptacle Juice SpoutScrew Peg Power Juicer Base Power Juicer Pulp Collector JACK LALANNE POWER JUICER PARTS LIST (Crescent tool pegs fit here to tighten.)(Pegs fit into blade.) Power Juicer Lid with Built-in Pulp Guard... -
Page 6: Assembly
JACK LALANNE POWER JUICER Assemble as shown STEP 1: Place base on a dry flat surface with locking bar in down position as shown. In front of the machine (spout side). STEP 2: Place receptacle on the base, with juicer spout facing direction of locking bar. - Page 7 JACK LALANNE POWER JUICER ASSEMBLY STEP 4: Place blade inside filter, centered over screw peg. Using orange crescent tool, place its pegs into the holes in the blade and turn clockwise until tightened. IMPORTANT: Do not over tighten as the screw peg will break.
-
Page 8: Disassembly
JACK LALANNE POWER JUICER IMPORTANT: Before disassembling the unit make sure you turn the power OFF and unplug the machine from the electrical outlet. STEP 1: Remove pusher from the chute. Pulp Guard STEP 3: Remove lid with pulp guard, and pulp collector. -
Page 9: Cleaning Your Power Juicer
Rinse the filter from the outside under running water. • Dry components thoroughly then assemble the machine and turn the power on to spin out any excess water. • Make sure the Power juicer and parts are completely dry then store in a cool, dry place. (CONT.) STEP 6: Remove receptacle from base. -
Page 10: Troubleshooting
• Check that all parts are assembled properly and in the correct position. • Juicing overripe fruit may result in too much pulp and will clog the filter. Turn Power juicer off and clean the filter. • The motor needs to warm up for 10 seconds before use. - Page 11 $5.99 s&h. Total $25.98. “Recipes for Healthy Living” Cookbook for only $9.99 plus $1.99 s&h. Total $11.98. Power Juicer Blade Replacement Kit for only $19.99 plus $4.99 s&h. Total $24.98. Power Juicer Pulp Replacement Kit for only $9.99 plus $2.99 s&h. Total $12.98.
- Page 12 We are very proud of the design and quality of our Power Juicer. This product has been manufactured to the highest standards. Should you have any problem our friendly customer service staff is here to help you if you have a question.