Using Live Viewer (Mac) - Samsung SDS-V4040 User Manual

• if Microsoft Silverlight plug-in is already installed
1. Use a web browser to connect to the DVR.
2. If Silverlight plug-in is already installed, you will see the
screen as shown.
3. If this is the case, perform Step 3 [tcP port & Web
Viewer port settings] below.
4. If the screen above does not appear, check if the DVR set is connected properly with a valid IP address.

uSing liVe VieWer (MAc)

The Live Viewer screen consists of following :
a
c
d
e
f
g
h
i
a This displays the IP address and the model name of the connected DVR.
b These menus consist of <liVe>, <About>.
c These buttons are used for the screen split and full screen mode. (Max. : 9CH)
d Shows the IP address and model name of the connected DVR.
e Select to turn the sound on/off.
f Select <dVr time> or <Pc time> for the OSD time information display setting of the Live Viewer.
g These buttons are used for sequence and changing the screen channel.
h These buttons are used for capture, print, and save the image.
When you can't play the file recorded in web, install the H.264 CODEC
ex) MAC: perian_1.2.3.dmg (http://perian.org)
i Shows the channel of the connected DVR.
j This displays the screen for connected camera with DVR.
b
j
English _81