Samsung SDS-V4040 User Manual page 43

5. Press <OK> in the "System upgrade" window.
While updating, it shows the progress.
`
• Updating progresses with 3 steps as shown in the figure.
6. When the updating is done, it automatically restarts.
Do not turn the power off until it finishes restarting.
If "Upgrade Failed" appears, retry from the step 4.
`
M
When you experience continued failure, consult the service
center for assistance.
When you perform S/W update remotely using Smart Viewer,
`
it may take a max of 3 minutes to complete the update since
Smart Viewer popped up a confirmation message. This is to
guarantee that the DVR set operates stably. For a faster
update, use the USB cable to connect to the DVR set.
System Management
System Information
Settings
 System Information
 Software Version V1.0xh_yymmddhhmmss
 Broadcast Format S/W Upgrade
NTSC
 MAC Address 00:00:F0:54:FF:FF
Software upgrading...
 S/W Upgrade
 Device USB2FlashStorage Upgrade
 Version V1.0xh_yymmddhhmmss
Previous
System Management
System Information
Settings
 System Information
 Software Version V1.0xh_yymmddhhmmss
S/W Upgrade
 Broadcast Format S/W Upgrade
NTSC
 MAC Address 00:00:F0:54:FF:FF
Software upgrading...
Software upgrading...
 S/W Upgrade
Do not turn off during the upgrade.
 Device USB2FlashStorage Upgrade
 Version V1.0xh_yymmddhhmmss
Previous
English _43