Operating The Cleaner; Installing Robotic Vacuum Cleaner; Installation Order; Turning The Power Switch On Or Off - Samsung SR8F3 Series User Manual

Operating the cleaner

INSTALLING THE ROBOTIC VACUUM CLEANER

INSTALLATION ORDER

1. Turning the Power Switch on or off

To use the robotic vacuum cleaner, you must turn on the Power Switch at the
bottom of the main unit.
2. Installing the Charger
To charge the robotic vacuum cleaner, you must fi rst install the
charger.
Since the battery is discharged when the product is
purchased, you must fully charge the battery before use.
3. Charging the Battery
You should charge the battery completely before using the
robotic vacuum cleaner.
4. Installing the VIRTUAL GUARD
You can confi ne the robotic vacuum cleaner to a particular
section by using Fence (virtual wall) mode.
5. Installing the air freshener
Please install the air freshener before using the robotic vacuum cleaner.
If the air freshener is installed, the robotic vacuum cleaner will give off a pleasant
fragrance.
TURNING THE POWER SWITCH ON OR OFF
To use the robotic vacuum cleaner, you must turn the
Power Switch on.
If you turn the Power Switch off, all settings will be reset.
1. Turn over the main unit and turn the Power Switch
on.
- If the icons are not turned on, it indicates that the
battery charge is depleted. In this case, dock the
robotic vacuum cleaner to the charger station after
turning the Power Switch on.
- Note that turning the Power Switch off will reset all
settings.
✽ When no key is pressed for approximately 10 minutes when the
power is on, the power is automatically turned off to save battery
power. In this case, to use this robotic vacuum cleaner again, please
push the "Power" button or "Start/Stop" button.
If the Power Switch is turned off, the robotic vacuum cleaner will not be charged
even if it is docked with the charger station.
CAUTION
20_ Operating the cleaner