Pnp/Pci Configurations; Pnp/Pci Configurations Menu - Foxconn 945G7AD Manual

PnP/PCI Configurations

v
Init Display First
This option is used to set which display device will be used first when your PC
starts up.
v
Reset Configuration Data
This option is used to define the system resource control scheme.If all cards
you use support PNP,then select Auto (ESCD) and the BIOS wil automatically
distributes interruption resources.If the ISA cards you installed not support-
ing PNP, you will need to select "Manual" and manually adjust interruption
resources in the event of hardware conflicts.However,since this motherboard
has no ISA slot,this option doesn't apply.
v
Resources Controlled By
This option is used to set whether the system is permitted to automatically
distribute IRQ DMA and I/O addresses when each time that the machine is
turned on. The setting values are: Disabled and Enabled.
vIRQ Resources
Press the <Enter> key, then manually set IRQ resources.
vPCI/VGA Palette Snoop
If you use a non-standard VGA card, use this option to solve graphic accelera-
tion card or MPEG audio card problems (e.g., colors not accurately displayed).
vINT Pin 1-8 Assignment
This option is used to name the interrupt request (IRQ) line assigned to a
device connected to the PCI interface on your system.
vMaximum Payload Size
This option is used to set maximum TLP payload size for PCI Express devices.
The unit is byte.
44

PnP/PCI Configurations Menu

Chapter 3 BIOS Description