Power Management Setup - ECS GeForce 6100PM-M2 Manual

Onboard AUDIO Function (Auto)
Use this item to enable or disable the onboard audio device.
OnBoard LAN Function (Auto)
Use this item to enable or disable the onboard LAN function.
OnBoard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
USB Controller (Enabled)
This item enables the USB controller. Leave this at the default "Enabled" if you want
to connect USB devices to your computer.
Press <Esc> to return to the main menu setting page.

Power Management Setup

This page sets up some parameters for system power management operation.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
ACPI Suspend Type
PWRON After PWR-Fail
Soft-off by PWR-BTTN
Resume By Ring
Resume By PCI/PCI-E/Lan PME
Resume By USB (S3)
Resume By PS2 KB (S3)
Resume By PS2 MS (S3)
Resume By RTC Alarm
: Move Enter : Select
F1:General Help
Power Management Setup
S3 (STR)
Power Off
Instant Off
Select the ACPI
Disabled
state used for
Disabled
System Suspend.
Disabled
Disabled
Disabled
Disabled
+/-/: Value F10: Save ESC: Exit
F9: Optimized Defaults
Using BIOS
Help Item
37