Advertisement
Available languages
Available languages
Oven
Door
Leveling Legs
Do not place excessive weight on or stand on an open
o_en door. This could cause [he range to tip over. break
the door. or injure the user.
Do not attempt to open or close door or operate oven until
door is properly replaced.
NeveHplace fingers between hinge and front oven frame.
Hinge arms are sprung mounted. Jf accidentally hit. the
hinge wiii siam shut against oven frame and could injure
your fingers.
To remove:
1. When cool, open the oven door to
the first stop position (opened
about four inches}.
2. Grasp door at each side. Do not
use the door handle to lift door.
3. Lift up evenly until door clears
hinge arms.
To replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges.
Door should not appear crooked.
Note: The oven door on a new range may feel "spongy"
when it is closed. This is normal and will decrease with use.
Oven
Window
(select
models}
To protect
the oven
door
window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or other
objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Be Sure the antbtip bracket secures one of the rear
from accidentally tipping.
Oven
Light
(select
models}
Disconnect power to range before replacing Rightbulb,
when repUacingbuUb.
Do not touch hot bul b W!th a damp cbth as this may cause
the bulb to break.
To Replace
Oven Light Butb:
1, When oven iscool, hold bulb cover (if equipped} in place, then
slide wire retainer off cover,
Note: Bulb cover will fall if not held in place while removing
wire retainer.
J
2. Remove bulb cover and light bulb.
BULB
COVER
3. Replace with a @-watt appli-
ance bulb.
4. Replace bulb cover and se-
cure with wire retainer.
5. Reconnect power to range.
Reset clock.
RETAINER
23
Advertisement
