Table of Contents
Advertisement
the temperature:
Connect the power cord to a properly grounded outlet. In the event of a power interruption, all
previous temperature settings are automatically erased and each compartment will default to a
preset temperature setting of: 6
compartment.
Set the desired cooling temperature by pressing the buttons adjacent to the "set upper/set lower"
program. Each depression of the buttons will scroll through the available temperature settings
(for each compartment) in decreases of 1 degree. The temperature selected will flash in the LED
display for approximately 5 seconds, then revert back to display the temperature of the internal
cabinet
Upper compartment: The temperature setting can be adjusted from 5
Lower compartment: The temperature setting can be adjusted from 12
To view the "set" temperature. (anytime) press and hold the corresponding button for
approximately 5 seconds, the "set" temperature will temporarily "flash" in the LED display for 5
seconds.
This unit has the option to display temperatures in either Celsius or Fahrenheit. To change the
•
setting, press and hold both buttons (Set Upper/Set Lower) simultaneously for approximately 5
seconds, a prompt (beep) will sound and the blue pilot light adjacent to the C or F mode
illuminates. (Due to different market, some units can only display Fahrenheit or Celsius)
NOTE:
• If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before restarting the
unit. If you attempt to restart before this time delay, the Wine Cellar will not start and cause
inappropriate impact.
• When you use the Wine cellar for the first time or restart the Wine cellar which is without use for a
long time, there could be a few degrees variance between the temperature you select and the one
indicated on the LED readout. This is normal and it takes time to recover. The Wine cellar will go
back to normal after several hours running.
•
Interior Light
You can turn the interior light ON or OFF by pushing the button marked with the "light" symbol
Door Lock
Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the User's Guide. Insert the key into the
lock and turn it counterclockwise to unlock the door. To lock the door do the reverse operation
making sure metal pin is engaged completely. Remove the key and place it in a secure place for
safekeeping.
Chapter 4 : CARE AND MAINTENANCE
Replacing LED Light
You must cut off electrical power avoid tip-and-run hurt.
Please remove 2 fixed screws of the top shelf by Philips screwdriver and take out the shelf.
(Attention please: LED light is covered by electrical box.)
Please take out lock screw by Philips screwdriver first, then push the light cover to left, you
can take out it when light cover set out limited location. (Fig.A)
Please pull out Housing 4 from 6 of LED light board. (Fig. B)
Please take out 2pcs of screw 5 by Philips screwdriver. (Fig.C)
Please pull out LED light board 6 from light cover. (Fig.D)
Please replace new LED light according above method.
(43
) for upper compartment and 12
℃
℉
6
( 54
) for lower
℃
℉
to 12
(40
to 54
℃
℃
℉
to 18
(54
to 65
℃
℃
℉
) .
℉
) .
℉
.
Hide quick links:
Advertisement
Table of Contents
