To reduce the risk of fire, electrical shock, or injury when using your appliance, follow
these basic precautions:
Read all instructions before using the Wine Cellar.
Before you throw away your old Wine Cellar: Take off the door and remove the
shelves in place so that children may not easily climb inside.
Never allow children to operate, play with, or crawl inside the appliance.
Never clean appliance parts with flammable fluids. The fumes can create a fire hazard
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of
this or any other appliance. The fumes can create a fire hazard or explosion.
Keep these instructions for reference
Before Using Your Wine Cellar
Remove the exterior and interior packing.
Before connecting the Wine Cellar to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
Clean the interior surface with lukewarm water and soft cloth.
Install the handle on the side of the door according user's desire.
When replace the illuminating lamp, please select the lamp which is complied with the rated
power input of lamp according to the rating label. Shut off the power supply before replacing
When disposing your appliance, please choose an authorized disposal site.
Installation of Your Wine Cellar
Place your Wine Cellar on a floor that is strong enough to support it when it is fully loaded. To
level your Wine Cellar, adjust the front leveling leg at the bottom of the Wine Cellar.
Locate the Wine Cellar away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
Avoid locating the unit in moist areas.
Plug the Wine Cellar into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized product service
IMPORTANT SAFETY INSTRUCTIONS