INDEX RECOMMENDATIONS AND SUGGESTIONS ........................3 CHARACTERISTICS ................................4 INSTALLATION..................................5 USE ......................................8 MAINTENANCE ..................................9...
RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. INSTALLATION • The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
INSTALLATION Boring the wall If you want to use the hood in suction version with the air outlet at the back of the hood, make sure to follow the indications given below in the drawing for a correct boring operation of the air outlet opening.
Page 6
Hood body assembly • Adjust the two screws Vr of brackets 11a, by just placing them in position. • Hook the hood body to the two brackets 11a. • Pull the Comfort Panel to open it, remove the filters one by one, push them towards the rear part of the unit and pull downwards at the same time .
Page 7
AIR OUTLET IN A RECYCLING HOOD VERSION • In case the components requested for the recycling functioning have been removed earlier these have to be positioned again. • Put the plastic tube onto the flange 7. • Place the air outlet grid 8 on the air outlet. Make sure that the position of the grid is correct.
Control panel Button Function Turns the lighting system on and off at maximum On/Off intensity. Turns the lighting system on and off in Courtesy Light On/Off mode. Turns the Motor off. Press and hold for approximately 5 seconds to Lock / The buttons turn light up one at a time in cycle.
MAINTENANCE REMOTE CONTROL (OPTIONAL) The appliance can be controlled using a remote control powered by a 1.5 V carbon-zinc alkaline batteries of the standard LR03- AAA type (not included). • Do not place the remote control near to heat sources. •...
Page 10
Metal grease filters They can be washed in the dishwasher, and need to be cleaned whenever Button G flashes or at least once every 2 months use, or more frequently if use is particularly intensive. Resetting the alarm signal • Turn the Lights and the Suction motor off, then disable the 24h function, if enabled.
Page 11
Activated Charcoal Filter (Recirculation Version) This cannot be washed or regenerated, and must be changed when G starts to flash, or at least once every 4 months. The Alarm signal, if it has been activated, only appears when the Suction motor is turned on.