Wlan Module - HP EliteBook Revolve 810 G3 Maintenance And Service Manual

WLAN module

Description
11ac+BT4 2x2 PCle+USB NGFF INDO
Intel Dual Band Wireless-N 7265AN 802.11 a/b/g/n 2×2 WiFi + BT 4.0 Combo Adapter
CAUTION:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service cover (see
Remove the WLAN module:
1. Disconnect the WLAN connector from the computer.
2. Disconnect the WLAN antenna cables (1) from the WLAN module terminals.
NOTE:
WLAN antenna cable labeled "2/AUX" connects to the WLAN module "Aux" terminal.
3. Remove the Phillips PM2.0×2.5 screw (2) that secures the WLAN module to the system board. (The
WLAN module tilts up.)
30 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To prevent an unresponsive system, replace the wireless module only with a wireless module
Battery on page
Service cover on page
The WLAN antenna cable labeled "1/MAIN" connects to the WLAN module "Main" terminal. The
25).
26).
Spare part number
783721-001
756748-001