Display Assembly - HP EliteBook Revolve 810 G3 Maintenance And Service Manual

Display assembly

Description
Display assembly, 11.6-in, HD, (1366×768), LED, LVDS, UWVA , ultraslim display (includes display hinge,
microphone, webcam, and Windows button)
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Solid-state drive (see
c. Keyboard (see
d. Bottom cover (see
e. System board (see
f. Hinge cover and hinge cap (see
Remove the display assembly:
1. Close the computer.
2. Turn the computer right side up with the rear toward you.
3. Remove the two Phillips PPM2.0×4.4 screws (1) that secure the display assembly to the bottom cover.
4. Slide the bottom cover (2) away from the display assembly.
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 25), and then remove the following components:
Service cover on page
Solid-state drive on page
Keyboard on page 37)
Bottom cover on page
System board on page
Hinge cover on page
26)
32)
40)
46)
50)
Spare part number
801799-001