Hinge Cover - HP EliteBook Revolve 810 G3 Maintenance And Service Manual

NOTE: The thermal material must be thoroughly cleaned from the surfaces of the fan/heat sink assembly
and the system board each time the fan/heat sink assembly is removed. Replacement thermal material is
included with the fan/heat sink assembly and system board spare part kits. Thermal paste is used on
the system board (1) and the section of the fan/heat sink assembly (2) that services it.
Reverse this procedure to install the fan/heat sink assembly.

Hinge cover

Description
Hinge cover (includes hinge cap, WWAN antenna cables and transceivers, and WWAN antenna shield)
Before removing the hinge cover, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Solid-state drive (see
c. Keyboard (see
d. Bottom cover (see
e. System board (see
Remove the hinge cover:
1. Remove the shield (1) that secures the WWAN antenna cables (2) in the routing channel built into
the bottom cover.
50 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 25), and then remove the following components:
Service cover on page
Solid-state drive on page
Keyboard on page 37)
Bottom cover on page
System board on page
26)
32)
40)
46)
Spare part number
753714-001