optris PI 160 Operator's Manual page 50

50
1. Insert the installation CD into the according drive on your computer. If the autorun option is
activated the installation wizard will start automatically.
2. Otherwise start setup.exe from the CD-ROM. Follow the instructions of the wizard until the
installation is finished.
The installation wizard places a launch icon on the desktop and in the start menu:
Start\Programs\PIConnect
To uninstall the software from your system use the uninstall icon in the start menu.
1. To connect the camera to the PC, plug the USB cable to the camera first. Afterwards connect it
with the PC.
2. To disconnect the camera and the computer remove the USB cable from the computer first and
then disconnect it from the camera.
After the software has been started the live image from the camera is shown inside a window on your
PC screen.
3. Install the calibration data at first start of the software (supplied on the CD).