Advertisement
Installation
Instruction
Inside
freezer
compartment
Step 9
Remove screw (A) that holds elec-
trical plug cover in place. Discard
screw and cover.
Remove light shield insert
(B)
and
discard it.
*Loosen two screws
(C) approxi-
mately
1
/2' . '
DO
NOT REMOVE THESE
SCREWS.
r
I
H
removed
Step 10
Cut the fill tube extension (5) to t h e B
length with a sharp knife or single-
edge razor blade and slide
it
onto the
fill tube against the stop.
Step 11
Place icemaker in freezer compart-
ment as shown. Insert icemaker power
cord plug (0) into socket on side wall,
making sure prongs are matched to
corresponding holes and plug is firmly
seated in socket.
I
I
1
Step 12
Lift icemaker and position rear open-
ing in fill cup
(E)
over fill tube ex-
tension (5). Hang icemaker on two
screws (Cy
Make sure:
electrical plug
is
still firmly in
socket.
fill tube extension (5) is still in fill
cup opening-check rear of refriger-
ator to make sure fill tube has not
been pushed out of the back of the
refrigerator.
icemaker mounting screws are 10-
cated in uppermost position of mount-
ing slots.
ING SCREWS SECURELY
THEN TIGHTEN ICEMAKER MOUNT-
/
Step
13
The icemaker should feel secure when
you lift the icemaker feeler arm (F) to
the "OFF" (up) position. Leave
it
there
until the refrigerator is connected to
the water supply to prevent premature
operation.
Step 14
Put ice bucket (7) into place directly
under icemaker (to the left and all the
way
to
the rear of the shelf under
icemaker).
NOTE: Check again to make sure the
icemaker power cord plug is fully
in-
serted into its socket with prongs
matched to corresponding holes.
Check again to make sure icemaker
feeler arm(F) is in "OFF"(up) position,
Step 15
A label (8) is provided in the kit to record
the date of installation for warranty
purposes. Apply it to the back of the
refrigerator.
Step 16
The warranty for
the icemaker is
printed on the back page of this book-
let. Keep this booklet with
your
Refrigerator Use &Care book.
The icemaker installation is now com-
plete. Refer to water line hook-up
instructions on the back of the refrig-
erator for connection to home water
supply. After water line installation is
completed, lower icemaker feeler arm
to the "ON" (down) position.
lcemaking cycle will not begin until
icemaker and freezer compartment
reach operating temperature, then
icemaking will begin automatically.
\
,
bucket
13
Advertisement
