Advertisement
Installation
Instruction
Inside
freezer
compartment
MODELS THAT CALL FOR THIS
INSTRUCTION SHEET NEED A
HIGHER BUCKET SUPPORT AND
DIFFERENT FILL TUBE THAN
I S
PROVIDED IN THIS KIT. THIS
HIGHER SUPPORT CAN ONLY
BE USED ON MODELS WITH
INSTRUCTION 6.
Obtain this
new support and a fill tube
extension at no charge by requesting
Pub.
No. 2-1003 from General
Electric Publications,
c/o
Dri-View
Manufacturing Co., 4706 Allrnond
Ave., Louisville, KY 40209.
Step
9
Remove screw (A) that holds electri-
cal plug cover in place. Discard screw
and cover.
Loosen two screws (C) amroxi-
mately 1/2". DO NOT REMOVE THE
SCREWS.
Step 10
Take the fill tube extension (5) from the
supplementary kit 2-1003 that you got
bv mail and slide it onto the fill tube
Gainst the stop.
r
1
I
Step 11
Place icemaker in freezer compart-
ment as shown. Insert icemaker power
cord plug (D) into socket on side Wall,
making sure prongs are matched to
corresponding holes and plug is firmly
seated in socket. When inserted,
power cord plug should fit flush to
freezer wall.
Step 12
Lift icemaker and position rear open-
ing in fill cup (E) over fill tube exten-
sion (5). H a g icemaker
on
two
screws
(C).
Make sure:
electrical plug is still firmly in
socket.
fill tube extension (5) is still in fill
cup opening-check rear of refriger-
ator to make sure fill tube has not
been pushed out of the back of the
refrigerator.
icemaker mounting screws are lo-
cated in uppermost position of mount-
ing slots.
THEN TIGHTEN ICEMAKER MOUNT-
ING SCREWS SECURELY.
1
Step 13
The icemaker should feel secure when
you lift the icemaker feeler arm
(F)
to
the "OFF" (up) position. Leave
it
there
until the refrigerator is connected to
the water supply to prevent premature
operation.
12
icemaker
will
operate
Step 14
Step 15
A label (8) is provided in the kit
to
record
the date of installation for
warranty
purposes. Apply
it to
the back of the
refrigerator.
Step
16
The warranty for the lcemaker is
printed
on
the back page of this book-
let. Keep this booklet with
your
Refrigerator Use & Care book.
The icemaker installation
is
now
com
Dlete. Refer
to
water
line
hook-up
NOTE: Check again to make sure the
icemaker power cord plug is fully in-
serted into
its socket with
Icemaking cycle will
not
begin until
matched to corresponding holes.
icemaker and freezer compartment
reach
ooeratino temoerature. then
Check again to make sure the ice-
icemaking
begin automatic
IJV.
maker feeler arm
(F)
is in the
"OFF"
(up) position.
3
.
- r -
~~
Advertisement
